DeLonghi DINAMICA plus Instructions For Use Manual page 21

DISPLAYED MESSAGE
ADD GROUND COFFEE MAX.
ONE MEASURE
FILL BEANS CONTAINER
GROUND TOO FINE. ADJUST
MILL
INSERT WATER SPOUT
POSSIBLE CAUSE
Preparation with pre-ground coffee has been
selected.
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The grinding is too fine, so that the coffee is
delivered too slowly or not at all.
If the water softener filter (D6) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
The hot water spout (D6) is not inserted or is
inserted incorrectly
REMEDY
Make sure the funnel (A4) is not blocked, then
add one level measure (D2) of pre-ground
coffee, press "Next" on the display and follow
the instructions in section "7.4 Making coffee
using pre-ground coffee".
Fill the beans container (A4) (fig. 10).
Empty the funnel with the aid of the brush
(D5) as described in section "12.8 Cleaning the
pre-ground coffee funnel".
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 12) one click clock-
wise towards "7" while the coffee mill is in
operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section"7.5 Adjusting the coffee mill"). If the
problem persists, make sure the water tank
(A17) is fully inserted.
Insert the hot water spout (D6) in the appli-
ance and deliver a little water until the flow
becomes regular. If the problem continues,
remove the filter (section 15.3 Removing the
filter).
Insert the water spout as far as it will go.
21