Table of Contents
Advertisement
1. To activate the sleep timer, turn the unit on and tap the FUNCTION button to select FM radio,
CD, Bluetooth or listening to music via AUDIO IN
2. Tap the SLEEP button on remote control, the sleep time icon
3. Repeatedly tap the SLEEP button to select a sleep time. The unit will turn off after 10, 20, 30,
40, 50, 60, 70, 80 or 90 minutes. Wait for 3 seconds after your selection for the unit to confirm
the selection, the unit will play for the selected length of time then automatically turn off.
4. To cancel the sleep timer, tap the SLEEP button repeatedly until timer shows "OFF", the sleep
time icon
disappears on the display
5. To turn the unit off before the selected length of time, press the STANDBY-ON
time.
Notes:
1.) To check the remaining sleep time, tap the SLEEP button once.
2.) If you are falling asleep to music from an external device connected to the AUX input, the
sleep timer will shut off the power to this system but it will not turn off the external device.
If the system does not respond or has erratic operation, you may have experienced an
electrostatic discharge (ESD) or a power surge that triggered the internal computer to shut down
automatically. If this occurs, unplug the AC cord from power
the AC cord to power source again. The unit will be reset, you need to setup the clock, alarm and
preset radio channels.
1.
Do not subject the unit to excessive force, shock, dust or extreme temperature.
2.
Do not tamper the internal components of the unit.
3.
Clean your unit with a dry cloth. Solvent or detergent should never be used.
4.
Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
Keep your unit away from heating appliances and sources of electrical noise such as
5.
fluorescent lamps or motors.
If drop-outs or interruptions occur in the music during CD play, or if
6.
the CD fails to play at all, its bottom surface may require cleaning.
Before playing, wipe the disc from the center outwards with a good
soft cleaning cloth.
CLEANING THE UNIT
To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use
caution when cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or
polishes as these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
RESETTING
CARE AND MAINTENANCE
E-16
appears on the display.
source,
wait for 60
seconds,
button at any
then plug
Advertisement
Table of Contents
