Lan Dhcp Setup Screen; Figure 42 Network > Lan > Dhcp Setup; Table 35 Network > Lan > Ip; Table 36 Network > Lan > Dhcp Setup - ZyXEL Communications P-2304R-P1 Series User Manual

Chapter 7 LAN
Each field is described in the following table.
Table 35 Network > LAN > IP
LABEL
IP Address
IP Subnet Mask
Apply
Reset

7.2.2 LAN DHCP Setup Screen

Use this screen to enable, disable, and configure the DHCP server in the ZyXEL Device. To
access this screen, click Network > LAN > DHCP Setup.
Figure 42 Network > LAN > DHCP Setup
Each field is described in the following table.
Table 36 Network > LAN > DHCP Setup
LABEL
DHCP Setup
Enable DHCP
Server
IP Pool Starting
Address
90
DESCRIPTION
Enter the IP address of the ZyXEL Device on the LAN.
Note: This field is the IP address you use to access the ZyXEL
Device on the LAN. If the web configurator is running on
a computer on the LAN, you lose access to the web
configurator as soon as you change this field and click
Apply. You can access the web configurator again by
typing the new IP address in the browser.
Enter the subnet mask of the LAN.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to set every field in this screen to its last-saved value.
DESCRIPTION
Select this if you want the ZyXEL Device to be the DHCP server on the LAN. As a
DHCP server, the ZyXEL Device assigns IP addresses to DHCP clients on the
LAN and provides the subnet mask and DNS server information.
Enter the IP address from which the ZyXEL Device begins allocating IP
addresses, if you have not specified an IP address for this computer in Network >
LAN > Static DHCP.
P-2304R-P1 Series User's Guide