Initial Setup Example; Overview; Configuring An Ip Interface; Figure 24 Initial Setup Network Example: Ip Interface - ZyXEL Communications ZyXEL Dimension ES-4024 User Manual

This chapter shows how to set up the switch for an example network.

5.1 Overview

The following lists the configuration steps for the example network:
• Configure an IP interface
• Configure DHCP server settings
• Create a VLAN
• Set port VLAN ID

5.1.1 Configuring an IP Interface

On a layer-3 switch, an IP interface (also known as an IP routing domain) is not bound to a
physical port. The default IP address of the switch is 192.168.1.1 with a subnet mask of
255.255.255.0.
In the example network, since the RD network is already in the same IP interface as the
switch, you don't need to create an IP interface for it. However, if you want to have the Sales
network on a different routing domain, you need to create a new IP interface. This allows the
switch to route traffic between the RD and Sales networks.

Figure 24 Initial Setup Network Example: IP Interface

1 Connect your computer to any Ethernet port on the switch. Make sure your computer is
in the same subnet as the switch.
2 Open your web browser and enter 192.168.1.1 (the default IP address) in the address bar
to access the web configurator. See
Chapter 5 Initial Setup Example
C

Initial Setup Example

Section 4.2 on page 49
ES-4024A User's Guide
H A P T E R
for more information.
5
57