Static Route; Chapter 26 Static Route; Configuring Static Routing; Figure 117 Ip Application > Static Routing - ZyXEL Communications XGS-4528F User Manual

C
H A P T E R
This chapter shows you how to configure static routes.

26.1 Configuring Static Routing

Static routes tell the Switch how to forward IP traffic when you configure the TCP/IP
parameters manually.
Click IP Application > Static Routing in the navigation panel to display the screen as shown.
Figure 117 IP Application > Static Routing
The following table describes the related labels you use to create a static route.
Table 83 IP Application > Static Routing
LABEL
Active
Name
Destination IP
Address
IP Subnet
Mask
Gateway IP
Address
XGS-4528F User's Guide
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the subnet mask for this destination.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
Switch that will forward the packet to the destination. The gateway must be a router
on the same segment as your Switch.
26

Static Route

227