ZyXEL Communications XGS-4528F User Manual page 57

Table 6 Navigation Panel Links (continued)
LINK
Auth and Acct
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized
Loop Guard
IP Application
Static Route
RIP
OSPF
IGMP
DVMRP
DiffServ
DHCP
VRRP
Management
Maintenance
Access Control
Diagnostic
Syslog
Cluster
Management
MAC Table
IP Table
ARP Table
Routing Table
Configure Clone
XGS-4528F User's Guide
DESCRIPTION
This link takes you to screens where you can configure authentication and
accounting services via external servers. The external servers can be either
RADIUS (Remote Authentication Dial-In User Service) or TACACS+ (Terminal
Access Controller Access-Control System Plus).
DHCP and ARP packets in your network.
This link takes you to a screen where you can configure protection against network
loops that occur on the edge of your network.
This link takes you to a screen where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
This link takes you to a screen where you can configure the RIP (Routing
Information Protocol) direction and versions.
This link takes you to screens where you can view the OSPF status and configure
OSPF settings.
This link takes you to a screen where you can configure the IGMP settings.
This link takes you to a screen where you can configure the DVMRP (Distance
Vector Multicast Routing Protocol) settings.
This link takes you to screens where you can enable DiffServ, configure marking
rules and set DSCP-to-IEEE802.1p mappings.
This link takes you to screens where you can configure the DHCP settings.
This link takes you to screens where you can configure redundant virtual router for
your network.
This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
This link takes you to screens where you can view system logs and can test port(s).
This link takes you to screens where you can setup system logs and a system log
server.
This link takes you to a screen where you can configure clustering management
and view its status.
This link takes you to a screen where you can view the MAC address and VLAN ID
of a device attach to a port. You can also view what kind of device it is.
This link takes you to a screen where you can view the IP addresses and VLAN ID
of a device attached to a port.You can also view what kind of device it is.
This link takes you to a screen where you can view the MAC address – IP address
resolution table.
This link takes you to a screen where you can view the routing table.
This link takes you to a screen where you can copy attributes of one port to
(an)other port(s).
Chapter 4 The Web Configurator
57