Advertisement
(*): Performance values are guaranteed at 38℃ temperature ambient.
• 2 2 2 2 0 0 – – 2 2 3 3 0 0 V V / / 6 6 0 0 H H z z m m o o d d e e l l s s : :
Climatic Class 5*:
– 43℃ (IEC/EN 60335-2-89)
(*): Performance values are guaranteed at 35℃ temperature ambient.
A A . . 6 6 T T r r a a n n s s p p o o r r t t , , h h a a n n d d l l i i n n g g a a n n d d s s t t o o r r a a g g e e
• Transport (i. e. transfer of the machine from one place to another) and handling (i. e.
transfer inside workplaces) must occur with the use of special and adequate means.
• Due to their size, the machines cannot be stacked on top of each other during transport,
handling and storage; this eliminates any risks of loads tipping over due to stacking.
• Do not stand under suspended loads during loading or unloading operations.
Unauthorized personnel must not enter the work area.
• The weight of the appliance alone is not sufficient to keep it steady.
• For machine lifting and anchoring, do not use movable or weak parts such as: casings,
electrical raceways, pneumatic parts, etc.
• Do not push or pull the machine to move it, as it may tip over. Use proper tool to lift the
machine.
• Arrange a suitable area with flat floor for machine unloading and storage operations.
• Machine transport, handling and storage personnel must be adequately instructed and
trained regarding the safely use of lifting systems and personal protection equipment
suitable for the type of operation carried out.
A A . . 7 7 I I n n s s t t a a l l l l a a t t i i o o n n a a n n d d a a s s s s e e m m b b l l y y
Introduction
• Machine installation and assembly operations must only be carried out by specialised
Technicians provided with all the appropriate personal protection equipment (safety
shoes, gloves, glasses, overalls, etc.), tools, utensils and ancillary means, with
adequate enclosure of the assembly area to keep out unauthorised persons.
• The operations described must be carried out in compliance with the current safety
regulations, regarding the equipment used and the operating procedures.
• Disconnect the appliance from the power supply before carrying out any installation
procedure.
Electrical connection
• Work on the electrical systems must only be carried out by a specialised personnel.
• Connection to the power supply must be carried out in compliance with the regulations
and provisions in force in the country of use.
• The information regarding the appliance power supply voltage is given on the dataplate.
• The system power supply is arranged and able to take the actual current absorption and
that it is correctly executed according to the regulations in force in the country of use;
• a differential thermal-magnetic switch suitable for the absorption specified on the data
plate, with contact gap enabling complete disconnection in category III overvoltage
conditions and complying with the regulations in force, is installed between the power
cable and the electric line. For the correct sizing of the switch or plug, refer to the
absorbed current specified on the appliance data plate.
• After making the connection, with the appliance running check that the power supply
does not fluctuate by ±10% the rated voltage.
17
Advertisement
