Advertisement
Reasonably foreseeable improper use
Improper use is any use different from that specified in this manual. During machine
operation, other types of work or activities deemed improper and that in general can involve
risks for the safety of operators and damage to the appliance are not allowed. Reasonably
foreseeable improper use includes:
• lack of machine maintenance, cleaning and periodical checks;
• structural changes or modifications to the operating logic;
• tampering with the guards or safety devices;
• failure to use personal protection equipment by operators, specialised personnel and
maintenance personnel;
• failure to use suitable accessories (e.g. use of unsuitable equipment or ladders);
• keeping combustible or flammable materials, or in any case materials not compatible
with or pertinent to the work, near the machine;
• wrong machine installation;
• placing in the machine any objects or things not compatible with its use, or that can
damage the machine, cause injury or pollute the environment;
• climbing on the machine;
• non-compliance with the requirements for correct machine use;
• other actions that give rise to risks not eliminable by the Manufacturer.
The previously described actions are prohibited!
Residual risks
• The machine has several risks that were not completely eliminated from a design
standpoint or with the installation of adequate protection devices. Nevertheless, through
this manual the Manufacturer has taken steps to inform operators of such risks, carefully
indicating the personal protection equipment to be used by them. Sufficient spaces are
provided for during the machine installation stages in order to limit these risks.
To preserve these conditions, the areas around the machine must always be:
– kept free of obstacles (e.g. ladders, tools, containers, boxes, etc.);
– clean and dry;
– well lit.
For the Customer's complete information, the residual risks remaining on the machine
are indicated below: such actions are deemed improper and therefore strictly forbidden.
R R e e s s i i d d u u a a l l r r i i s s k k
Slipping or falling
Burns/abrasions (e.g. heating
elements, cold pan, cooling
circuit plates and pipes)
Electrocution
Falling from above
D D e e s s c c r r i i p p t t i i o o n n o o f f h h a a z z a a r r d d o o u u s s s s i i t t u u a a t t i i o o n n
The operator can slip due to water or dirt on the
floor
The operator deliberately or unintentionally
touches some components inside the machine
without using protective gloves
Contact with live parts during maintenance
operations carried out with the electrical panel
powered
The operator intervenes on the machine using
unsuitable systems to access the upper part (e.g.
rung ladders, or climbs on it)
15
Advertisement
