Advertisement
D D . . 1 1 . . 1 1
P P r r o o c c e e d d u u r r e e s s f f o o r r h h a a n n d d l l i i n n g g o o p p e e r r a a t t i i o o n n s s
Before lifting:
• send all operators to a safe position and prevent persons
from entering the handling area;
• make sure the load is stable;
• make sure no material can fall during lifting. Manoeuvre
vertically in order to avoid impacts;
• handle the machine, keeping it at minimum height from the
ground.
D D . . 1 1 . . 2 2
P P l l a a c c i i n n g g t t h h e e l l o o a a d d
Remove the appliance from the wooden pallet, move it to one
side, then slide it onto the floor.
D D . . 2 2
U U n n p p a a c c k k i i n n g g
I I M M P P O O R R T T A A N N T T
Immediately check for any damage
caused during transport. Inspect the pack-
aging before and after unloading.
Remove the packaging. Take care when unpacking and
handling of the appliance to not cause any shocks on itself.
NOTE!
• The forwarder is responsible for the goods
during transport and delivery.
• Make a complaint to the forwarder in case of
visible or hidden damage.
• Specify any damage or shortages on the dis-
patch note.
• The driver must sign the dispatch note: the
forwarder can reject the claim if the dispatch
note is not signed (the forwarder can provide
the necessary form).
To unpack the machine, carrying out the following operations:
• cut the straps and remove the protective film, taking care
not to scratch the surface if scissors or blades are used;
• remove the cardboard top, the polystyrene corners and the
vertical protection pieces;
• for appliances with stainless steel cabinet, remove the
protective film very slowly without tearing it, to avoid leaving
glue stuck to the surface;
E E
T T E E C C H H N N I I C C A A L L D D A A T T A A
W W A A R R N N I I N N G G
Refer to " Warning and Safety
Information ".
E E . . 1 1
M M a a t t e e r r i i a a l l s s a a n n d d f f l l u u i i d d s s u u s s e e d d
The areas in contact with the product are in non-toxic plastic
material for the ventilated models and in galvanised iron
protected with stove baked transparent paint, with non-toxic
characteristics in compliance with current standards, for the
models with evaporating grille;
The "Wine-line" models are in steel, plastic black on the
outside, whereas the inside compartment is in polystyrene,
which is the best solution for cleaning and hygiene.
The fluorinated gases are contained in a hermetically sealed
device.
An HFC (R134a (GWP:1430) / R404a (GWP:3922)) or HC
refrigerant fluid for models with refrigerant R290 or R600a,
complying with the current regulations, is used in the
refrigeration units. The type and quantity of gas used are
given on the dataplate. The type and quantity of gas used are
given on the dataplate.
The CO2 equivalent of the gas may be calculated multiplying
GWP value by quantity of gas.
22
• should this happen, remove the traces of glue with a non-
corrosive solvent, rinsing it off and drying thoroughly;
• it is advisable to go over all the stainless steel surfaces with
a rag soaked in paraffin oil in order to create a protective film.
D D . . 2 2 . . 1 1
D D i i s s p p o o s s a a l l o o f f p p a a c c k k i i n n g g
The packing must be disposed of in compliance with the
current regulations in the country where the appliance is used.
All the packing materials are environmentally friendly.
They can be safely kept, recycled or burned in an appropriate
waste incineration plant. Recyclable plastic parts are marked
as follows:
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
Polystyrene foam
• Corner protectors
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
machine is used.
D D . . 3 3
S S t t o o r r a a g g e e
The machine and/or its parts must be stored and protected
from damp, in a non-aggressive place, free of vibrations and
with room temperatures between -10℃ [14℉] and 50℃
[122℉] .
The place where the machine is stored must have a flat
support surface to avoid deforming the machine or damage to
the support feet.
C C A A U U T T I I O O N N
The appliance must be levelled, other-
wise its operation could be affected.
E E . . 2 2
D D i i m m e e n n s s i i o o n n s s , , p p e e r r f f o o r r m m a a n n c c e e a a n n d d c c o o n n s s u u m m p p t t i i o o n n
T T e e c c h h n n i i c c a a l l c c h h a a r r a a c c t t e e r r i i s s t t i i c c s s
P P l l a a s s t t i i c c i i z z e e d d
/ / W W i i n n e e
Gross capacity L
400
Max room tempera-
+32
ture ℃
Power supply voltage
Power supply voltage
Power supply voltage
1.
Depending on the model.
F F u u l l l l y y i i n n s s u u l l a a t t e e d d d d o o o o r r r r e e f f r r i i g g e e r r a a t t e e d d m m o o d d e e l l s s 0 0 " " ℃ ℃ / / + + 1 1 0 0 ℃ ℃ " "
Temp. range. in
compartment
Room temperature
Refrigeration system
Plastic-coated racks mm:
600 x 400
F F i i s s h h / / A A i i s s i i
400
+32
230V / 50 Hz
220V / 60 Hz
220–230V /60 Hz
℃
0 / +10
℃
43
ventilated
no.
4
1
1
1
Advertisement
