Troubleshooting; Unable To Load The Media Properly; The Media Does Not Enter Properly, And They Bend And Warp; If You Are Using Rolled Media, Does The Leading End Tend To Curl Itself - Silhouette CAMEO5 User Manual

04

Troubleshooting

This chapter describes what to do if problems occur with Silhouette CAMEO5.

4-1 Unable to load the media properly

If the media cannot be loaded properly, check the following causes and solutions.

The media does not enter properly, and they bend and warp

If you are using rolled media, does the leading end tend to curl itself?

• If the leading end of the media tends to curl itself, it may be loaded with the media being warped, or the media
may not enter properly into the machine, which may cause the machine to be idle. Straighten the curled
section and load it straight.
If the media cannot be loaded properly, paste them on the cutting mat before loading.
• When loading the media, pull the media taut on the left and right sides with both hands to set.
• Move and set the Auxiliary Roller(s) onto the position where the media warp.
For details, refer to "2-1 Cutting with an Auto Blade".
04 Troubleshooting
63