Silhouette CAMEO5 User Manual page 62

5 Press the "MORE" button.
6 Select the "Cut" tab.
7
Select the "Auto Cross-Cutting" check box.
8
Set the "Cutting Position", save the setting, and close the screen.
9
Insert the Auto Blade.
10
Press the "SEND" button to start cutting.
If you enable auto cross-cutting, the created design is cut, and then the auto cross-cutting is performed.
During auto cross-cutting, the blade depth of the Auto Blade is automatically adjusted.
After performing auto cross-cutting, remove the cut media by hand.
This may cause the media to be stuck during the next cutting operation.
Additional information
Note
03 About the Silhouette Studio Screen
SEND button
62