Table of Contents
Advertisement
Equipment must be examined for damage and repairs before each use. The owner is responsible to perform routine testing of the
locking mechanisms. Worn or damaged components must be replaced immediately or the equipment removed from service until
the repair is made. Only manufacturer supplied components can be used to maintain and repair the equipment.
If at any time the Warning labels become loose, unreadable or dislodged, replace the labels. If purchased in US/Canada, contact
Customer Service for replacement labels. If purchased outside US/Canada, contact your local distributor for them.
The Bowflex™ SelectTech™ Dumbbell is a very low maintenance product. However, there are steps that you should take to keep the product
performing and looking its very best.
Should your SelectTech™ Dumbbell handle assembly, plates or base become soiled you may clean them with a cloth lightly dampened with
warm water and a small amount of mild soap. Wipe dry with a separate cloth.
The SelectTech™ Dumbbell is internally lubricated and will not require further internal lubrication. The contact between weight plates and
selection discs is not lubricated but has naturally low friction. This generally will not require any lubrication. Should you feel it necessary to
lubricate the weight plates and/or selection discs, use only a silicon lubricant, preferably "food grade".
Do not use any solvents, harsh detergents, chemicals or bleach on this product − doing so may damage the materials, resulting in
degradation of the product's performance or strength.
Do not attempt to disassemble the Handle Assembly. The Handle Assembly is not designed to be user serviced. Doing so will
void the manufacturers warranty. If purchased in US/Canada, contact Customer Service for assistance. If purchased outside US/
Canada, contact your local distributor for assistance.
Battery Icon Displayed on the Smart Dumbbell Module
The Console will display the battery icon for ten seconds when the batteries are at approximately 10% of their rated power
during power up. When replacing the batteries, make sure the batteries point in the +/- direction shown in the battery bay.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd, Ni-MH, etc) batteries.
1. Press and hold down the securing snap on the Sensor Assembly, and pivot the Sensor Assembly up and out from the dumbbell.
11
Assembly / Owner's Manual
Maintenance
Advertisement
Table of Contents
