Table of Contents
Advertisement
Page 6
What you should expect to find in the carton
Check to be sure that all of the following items have been included
in the carton along with this manual:
Clean Before Using
After you remove the unit from its packaging, clean the inside be-
fore using. See cleaning instructions in the Cleaning section of
this manual.
1. Place cooler on a dry surface where it is protected from water.
2. The cooler should not be used where it may be exposed to rain.
3. Never locate the cooler where the ambient temperature is be-
ALLOW COOLER TO SIT UPRIGHT FOR 24 HOURS BEFORE
TURNING ON, TO ALLOW THE COMPRESSOR LUBRICANT TO
DRAIN.
Keep flammable materials and vapors such as gasoline away from
appliances. Failure to do so can result in fire or explosion.
Electrical Connection
The cooler can be operated from either a DC or an AC power
source. Both require the use of the DC/DC power cord included
with the unit. With an AC source, the included AC/DC adapter
must be plugged into the end of the DC/DC power cord, then con-
nected to an AC source such as a wall socket.
DC Source: The cooler can be operated between 10.3V and 17V
AC Source: Be sure to use the AC/DC adapter when your power
SUMMIT APPLIANCE
Before First Use
1 compressor freezer, model SPRF26
1 DC/DC power cord
1 AC/DC adapter
Installation
low 0°C (32°F).
DC, or between 22V and 30V DC. Before connection, check
that the battery voltage falls within these ranges. If the voltage
is out of range, the cooler will not operate. Excessive voltage
could damage the electronic components of the cooler.
source is AC, otherwise the cooler could be damaged.
Advertisement
Table of Contents
