We advise you to keep this Owner’s Manual in your possession. Model: _______________________ Serial number: _____________________________ Options added: ___________________________________________________________ Date of Purchase _______________ Where Purchased___________________________ MODELS • SCR600LOS SERIES • SP6 DRAWER SERIES • SP6DS2DOS SERIES • SP6DSSTBOS SERIES • SPF5DSSTB •...
Remove doors from your old appliance. Leave shelves in place. If an old appliance contains refrigerants, it must be recycled by a licensed service or disposal company. APPLIANCE SAFETY IMPORTANT SAFETY INSTRUCTIONS! Felix Storch, Inc. SUMMIT PROFESSIONAL DIV.
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. INSTALLATION INSTRUCTIONS UNPACKING Use two or more people to move and install your appliance. ALLOW APPLIANCE TO SIT UPRIGHT FOR 24 HOURS BEFORE TURNING ON, TO ALLOW THE COMPRESSOR LUBRICANT TO DRAIN. 1. Remove packaging materials.
Page 4
6. After appliance is fully loaded, recheck with level as in Step 4. 7. If your appliance is equipped with casters, the two front casters have brakes to prevent rolling. Keep brakes locked, and unlock for moving only. www.summitapplianceparts.com Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. 718-893-3900 718-328-8700 (sales)
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. In order to ensure proper temperature, you need to permit proper airflow in the appliance. Do not block any air vents. If the vents are blocked, airflow will be prevented, and temperature and moisture problems may occur.
Simply line up the hinges on the drawer and the hinges on the appliance and gently push the drawer in. Once lined up, close the drawer completely, then open again to make sure the drawer is on track. APPLIANCE OPERATION www.summitapplianceparts.com Felix Storch, Inc. SUMMIT PROFESSIONAL DIV.
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. Cleaning Your Frost-Free Refrigerator Frost-free means that you do not have to defrost your appliance. Frost is removed by air moving and collecting any moisture and depositing it on the cooling coil. The cooling coil periodically warms up enough to melt the frost, and the water then flows down to the drain pan (located behind the base grill) where it is evaporated.
To reset this range lock, either call us or find information on our website under Troubleshooting. TEMPERATURE SELECTION INSTRUCTIONS FOR BOTH FOLLOW: DIGITAL THERMOSTAT INSTRUCTIONS Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. Up & Down arrows SET key...
Page 9
The lock is spring-loaded, so the key cannot be left in the lock. If the key is lost, contact your dealer or SUMMIT APPLIANCE to purchase a replacement. Always give the model and serial number of your appliance when requesting a replacement key. Keys for most models can be ordered online at www.summitapplianceparts.com...
Page 10
OFF position. OPERATION MODES SUMMIT alarms have two operating modes: NORMAL DISPLAY MODE and ALARM DISPLAY MODE. To change from one mode to another, press the MODE button once. NORMAL DISPLAY MODE is indicated by the display of current temperature and the MIN (minimum) and MAX (maximum) temperatures.
Page 11
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. INSTRUCTIONS FOR INTEGRATED FRAME (SUFFIX ’IF’) FOR BUILT-IN APPLICATIONS Note: The directions below are for installation under a cabinet in a 24 inch cutout space. If you will be using this product in a freestanding application, please skip below, and begin with step A1 in lower half of page.
Page 12
Page 12 APPLIANCE OPERATION (by Model) FF6BI – FF7BI – SCR600LOS – SPR7OS – SPR601OS – SCR600BI – SWC6GBI – ALB751 – ALB753B Series DEFROST SYSTEM, OPERATION AND SHELF ADJUSTMENT – All models of the above series are all-refrigerators, with no freezer compartment and an auto-defrost system. During the compressor operation, ice will build up along the cold rear wall (the evaporator plate is behind the wall).
Page 13
SPR7-OS series can be ordered from your dealer or at www.summitapplianceparts.com. Drawer refrigerators and SPR7-OSBI models are suitable for under-counter or built-in applications. SPR7-OS models, and SCR600LOS series and SPR601OS series are intended for free-standing use, and if put under a counter, provisions for adequate air flow must be provided (minimum 1 inch on sides and top and 2 inches at the rear).
If you need to order replacement parts, we recommend that you use only factory-specified parts. Factory-specified parts will fit right and work right because they are made with the same precision used to build every new SUMMIT® appliance. Check the plug, fuse and/or circuit breaker.
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. Try the solutions suggested here first to avoid the cost of an unnecessary service call ... Your refrigerator or freezer will not operate: Has a household fuse blown or circuit breaker tripped, or is the outlet not receiving power or is it switch-controlled? Replace the fuse or reset the circuit breaker.
Call customer service toll free in the U.S.A. @ 1- Order parts online at Order parts online at Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory specified parts and repair labor to correct defects in materials or workmanship.
Need help?
Do you have a question about the SCR600LOS SERIES and is the answer not in the manual?
Questions and answers