Canon Arizona 135 GT Operation Manual page 47

Roll
Enables or disables the Roll Media Option print queue (this allows you
check media parameters before the job actually prints). Roll media print
jobs will not print unless this icon is selected.
Roll Manager
The Roll Manager allows the operator to load and unload media and to ini-
tialise the Roll module so that the tension on the roll media is set and the
roll is ready to be printed on.
Create Batch In Batch Mode Operation individual print jobs are sent from the RIP to the
printer, and then combined on the printer to create a batch job for flatbed
printing. There are two types of batch mode jobs: Composite and Collated.
In a Composite batch all images are printed on a single piece of media
without interruption. Composite batch mode can be used to efficiently print
more than three data layers and/or mix print modes for a batch job.
A Collated batch prints a set of individual print jobs on individual pieces of
media, and then repeats the number of copies of the set, as required. The
gantry moves to the park position between each print job. The media is
changed and the media thickness is confirmed. Pushing the start button is
required to continue printing the next copy.
Refer to Customer Application Bulletin 45 "Batch Mode Operation" on our
website https://graphiplaza.cpp.canon for more details and examples.
Ink Temperature This icon switches the ink heater on or off and also displays the ink temper-
Control ature. The state of the button reflects the status of the ink heater. Status se-
lected means ink heater is on.
The printheads must be at operating temperature (45°C / 113°F) before a
job will start printing and to perform proper automatic maintenance. This
means that the ink heating must remain on at all times!
Table vacuum This icon controls the table vacuum and duplicates the function of the table
vacuum foot switch. The button reflects the actual state of the table vac-
uum. There is an automatic timeout that will turn the table vacuum off. The
actual time is set in the Settings module under Printer.
Move Gantry Moves the gantry from its parked position to the centre of the table.
Start
This icon can be used to start a flatbed print job (same function as the
physical button on the table).
NOTE
Roll media print jobs do not require user actions to start the print
job once Roll module is initialised (see Roll Media Manager in the
RMO). If this icon is selected, and the job status is not on Hold,
roll media print jobs will start automatically when the printer re-
ceives the job.
NOTE
If this button is flashing, it indicates an error. Click on the Ink Sta-
tus button to check the ink system.
NOTE
Once turned off, vacuum cannot be turned on again for approxi-
mately 5 seconds.
Print Job Control Module
Chapter 3 - Navigate the User Interface
4
47