Canon Arizona 135 GT Operation Manual page 220

Radio Interference suppression (all countries except USA)
• Warning (CISPR11/EN55011): Operation of this equipment in a residential environment could
cause radio interference.
FCC (USA)
• This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the User Documentation, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
• Do not make any changes or modifications to the equipment unless otherwise specified in the
User Documentation. If you make such changes or modifications, you could be required to stop
operation of the equipment.
• This equipment contains a certified modular transmitter. The transmitter's FCC ID label is
located near the power rating label. The modular transmitter is located in the ink supply unit
and can only be accessed by a service technician.
ICES/NMB; Interference-causing equipment (Canada)
• CAN ICES-3 (A)/NMB-3(A)
Conformity declaration for Radio Law (Japan)
This end device contains a radio device which is already approved by MIC AC-18004 for Radio
Law
Conformity declaration for Radio devices (USA and Canada)
• This equipment contains a certified modular transmitter. The modular transmitter is located in
the Ink bay and can only be accessed by a service technician.
• The transmitter's FCC ID is U2P-3010120604, the IC ID is 22117-301012060.
Laser Safety (All countries)
• CDRH regulations
This machine is certified as a Class 1 Laser product under Radiation Performance Standard
according to the Food, Drug and Cosmetic Act of 1990. Compliance is mandatory for Laser
products marketed in the United States and is reported to the Centre for Devices and
Radiological Health (CDRH) of the U.S. Food and Drug Administration of the U.S. Department
of Health and Human Services (DHHS). This means that the device does not produce
hazardous laser radiation. The related label indicates compliance with the CDRH regulations
and must be attached to laser products marketed in the United States.
CAUTION
Use of controls, adjustments or performance of procedures other than those specified in this
User Documentation may result in hazardous radiation exposure. This is a semiconductor
laser. The maximum power of the laser diode is 0.5 mW.
220 Chapter 11 - Regulation Notices