Communication Port Setting - Furuno FSS-301 Manual

3.3

Communication Port Setting

To set the communication port (NMEA1 to NMEA5), do the following.
1. Click the [Settings] icon (
vanced Settings] icon (
2. Select the [Tests] from the menu on the left-hand side of the window.
The [Tests] menu appears on the right-hand side of the window.
3. Select the [Communication Port Monitor] from the [Tests] menu.
The communication port monitor window appears.
Tabs
4. Select a port tab ([Serial Port 1] to [Serial Port 5]) to show the corresponding port.
5. Click the [Settings] button (
).
××.××
Advanced Settings
IDENTI-FISH
ID1
ID2
Alarm
System
Range
TX/RX
HF
LF
Control Unit
User Interface Settings
Calibration
HF
LF
Stabilization
HF
LF
Mode
Tests
Service
Communication Port Monitor
Serial Port 1
Serial Port 2
NMEA Fromat Ver1.5
Output Data Depth
TLL Output TLL
Echo Start Depth 0
Output Echo Cycle 1.0
Echo Resolution Auto
Manual 0.1
Peak
Echo Data Format
Baud Rate 4800
) from the InstantAccess bar
System : Tests
Maintenance Information
Communication Port Monitor
Activity Log
Control Unit Test
LCD Test
Rx Monitor
TD-ID
OK Apply
Serial Port 3 Serial Port 4 Serial Port 5
) to show the port setting menu.
Serial Port 1
OK Apply Cancel
3. INITIAL SETTINGS
™
, then click the [Ad-
Cancel
[Close] button
[Settings] button
3-11