How To Edit Registered Waypoints; How To Erase Waypoints; How To Set Destination Waypoint; Setting Up Nav Data Displays - Furuno FCV-628 Operator's Manual

1. OPERATION
4. Select item desired, then press the EN-
TER key to show corresponding input
box.
Waypoint name Latitude
5. Enter name or latitude and longitude as
applicable.
6. Press the MENU/ESC key to register the
window.
7. Press the MENU/ESC key again to close
the window.
1.20.2 How to edit registered
waypoints
Registered waypoints can be freely edited.
1. Open the menu, select [Data], then press
the ENTER key.
2. Select [WPT List], then press the ENTER
key.
3. Select the waypoint to edit, then press the
ENTER key.
4. Select the item desired, then press the
ENTER key.
5. Edit data as appropriate.
6. Press the MENU/ESC key twice to return
to the [WPT List].
1.20.3

How to erase waypoints

Waypoints can be erased two ways: individu-
ally or collectively. A waypoint set as destina-
tion cannot be erased.
How to erase individual waypoints
1. Open the menu, select [Data], then press
the ENTER key.
2. Select [WPT List], then press the ENTER
key.
3. Select the waypoint to erase, then press
the ENTER key.
4. The message "Erase?" appears; press
the ENTER key.
5. Select [Yes], then press the ENTER key.
6. Press the MENU/ESC key to close the
window.
How to erase all waypoints
1. Open the menu, select [Data], then press
the ENTER key.
2. Select [Delete All WPT], then press the
ENTER key.
Longitude
3. Select [Yes], then press the ENTER key.
1.20.4
Set a destination waypoint to show the range,
bearing and time-to-go to that point, on the
Nav data display. See the next section for de-
tails.
1. Open the menu, select [Data], then press
the ENTER key.
2. Select [Go to WPT], then press the EN-
TER key.
3. Select a destination waypoint, then press
the ENTER key.
1.21
The user may arrange the nav data displays
as desired.
1. Rotate the MODE knob to select the Nav
data display to change. (This window is
displayed for 10 seconds.)
2. Use  or  to select a data display win-
dow desired.
3. Use  or  to select the item to display.
The items that can be displayed depend
on the screen division.
20
How to set destination
waypoint
Setting Up Nav
Data Displays
/ : Window Selection
/ : Data Selection
[ENTER] : Set
[MENU] : Cancel