Advertisement
SECTION 2 - JLG SMART SYSTEM ™ ANALYZER KIT INSTRUCTIONS (CONTROLLER 1600286).
NOTE: The following information is to be used when working with the MACHINE SETUP menu. When configuring the E Series
scissor lift, the machine configuration must be completed before any personality settings can be changed. Changing the
personality settings first and then changing the model number of the machine configuration will cause the personality
settings to return to default values.
.
Table 2-3. Machine Configuration Programming Information (Machines equipped with 1600286 controller)
Configuration Digit
1
(MODEL NUMBER)
2
(TILT SWITCH)
3
(POWER DECK)
4
(DECK EXT. LIMIT
SWITCH)
5
(FUNCTION CUTOUT)
2-10
Number
1
MODEL 1532E
2
MODEL 1932E
3
MODEL 2033E
4
MODEL 2046E
5
MODEL 2646E
6
MODEL 2658E
0
No tilt switch installed.
1
Tilt switch installed with a lamp indicator in the platform control box.
2
Tilt switch installed with a lamp indicator in the platform control box and a cutout which
prevents the machine from driving or lifting up.
0
No power deck installed.
1
Machine equipped with power deck.
0
Deck extension limit switch not installed. (Option Number 2 must be used if there is a
power deck installed.)
1
Cuts out LIFT DOWN when deck is extended. This digit is used with roll out decks that
require a deck extension cutout. Sounds platform alarm for one second on, one sec-
ond off, one second on, and three seconds off while operator tries to perform the func-
tion that has been cut out (provided the platform alarm has been installed).
2
Cuts out HIGH DRIVE when deck is extended and below elevation. Cuts out DRIVE
when deck is extended and above elevation. This digit is used with a power deck.
Sounds platform alarm for one second on, one second off, one second on, and three
seconds off while operator tries to perform the function that has been cut out and dur-
ing the LIFT DOWN function (provided the platform alarm has been installed).
0
No function cutout installed.
1
Overload switch for French machines. — Cuts out all functions. Sounds platform
alarm for two seconds on, two seconds off, while operator tries to perform the function
that has been cut out (provided the platform alarm is installed).
2
Overload switch for Japanese machines. — Cuts out LIFT UP and DRIVE. Sounds
platform alarm for two seconds on, two seconds off, while operator tries to perform the
function that has been cut out (provided the platform alarm is installed).
Description
– JLG Sizzor –
Default Setting
Before
Programming
3
0
0
0
0
3120442
Advertisement
