Advertisement
SECTION 2 - JLG SMART SYSTEM ™ ANALYZER KIT INSTRUCTIONS (CONTROLLER 1600286).
LIFT
STEER
GROUND MODE
MACHINE
Pressing ENTER with any of the above displayed menus, will display additional sub-menus within the selected menu. In
some cases, such as DRIVE, the next level is the parameter or information to be changed. Refer to the flow chart for what
menus are available within the top level menus. You may only view the personality settings for selected menus while in
access level 3. Remember, you may always cancel a selected menu item by pressing the ESC key.
• Changing the access level of the hand held analyzer: (ALL 1600286 controllers)
When the analyzer is first connected, you will be in access level 3 which enables you to only view most configuration settings
which cannot be changed until you enter a password to advance to a lower level. This ensures that a setting cannot be acci-
dentally altered. To change the access level, the correct password must be entered. To enter the password, scroll to the
ACCESS LEVEL menu. For example:
MENU:
ACCESS LEVEL 3
Press ENTER to select the ACCESS LEVEL menu.
Using the UP or DOWN arrow keys, enter the first digit of the password, 3.
Then using the RIGHT arrow key, position the cursor to the right one space to enter the second digit of the password.
Use the UP or DOWN arrow key to enter the second digit of the password which is 3.
Repeat this process until you have entered all five digits of the password which is 33271.
Once the correct password is displayed, press ENTER.
The access level should display the following, if the password was entered correctly:
MENU:
ACCESS LEVEL 1
Repeat the above steps if the correct access level is not displayed or you can not adjust the personality settings.
• Adjusting configuration using the hand held analyzer on ALL 1600286 controllers:
Once you have gained access to level 1, and a personality item is selected, press the UP or DOWN arrow keys to adjust its
value, for example:
PERSONALITIES:
DRIVE ACCEL 1.0s
There will be a minimum and maximum for the value to ensure efficient operation. The value will not increase if the UP arrow
is pressed when at the maximum value nor will the value decrease if the DOWN arrow is pressed and the value is at the min-
imum value for any particular personality. If the value does not change when pressing the up and down arrows, check the
access level to ensure you are at access level 1.
When a machine digit item is selected, press the UP or DOWN arrow keys to adjust its value, for example:
GROUND ALARM:
2=DRIVE
The effect of the machine digit value is displayed along with its value. The above display would be selected if the machine
was equipped with a ground alarm and you wanted it to sound when driving. There are certain settings allowed to install
optional features or select the machine model.
3120442
– JLG Sizzor –
2-3
Advertisement
