Hytera HP50X User Manual page 28

User Manual
Phenomena
The radio fails to
communicate with group
members.
There is too much noise and
hiss.
If the above solutions cannot solve your problems, or you may have some other queries, please contact us or your local
dealer for more technical support.
Analysis
The speaker may be blocked or
damaged.
The frequency or signaling type may be
inconsistent with that of other members.
The channel type (digital/analog) may be
set inconsistently.
You may be too far away from the group
members.
The signal may be weak.
The radio may be in an unfavorable
position. For example, the signal may be
blocked by tall buildings or frustrated in
the underground areas.
The radio may suffer from external
disturbance (such as electromagnetic
interference).
Clean the surface of the speaker.
Set your TX/RX frequency and signaling to
the same as that of other members.
Make sure all members are on the same
digital/analog channel.
Move towards other members.
Make sure call participants are within the
communication range.
Move to an open and flat area, and restart
the radio.
Stay away from the equipment that may
cause interference.
23
Troubleshooting
Solution