Advertisement
Available languages
Available languages
NO.
1
Low battery
2
Automatic power-off mark
3
Display wet bulb temperature or dew-point temperature
4
Temperature measurement unit
5
Relative humidity measurement unit
6
MEM, RAM position number
7
Max-min
8
Hold function activated. The screen freezes the current
reading
Operation
Notice
When moving the meter from one atmosphere with extreme temperature
or humidity to another, you need to wait for it to stabilize. Press
start the meter and read the measurements displayed by °C or °F. Press
to switch.
Dew-point & Wet-bulb
When starting the meter, the ambient temperature appears on the
screen. To obtain DP, press a first time
time, WB is switched. Press
temperature back. A corresponding signal will be shown on the screen
indicating DP and WB.
Holding
Hold the button Press
meter from displaying the measurements. When the HOLD function is
active, the screen displays
value, press
again.
Max-min
Pressing
, Max-min is set up, and max updates constantly,
press
again, it is min. The two stations can be switched. If turned off,
you need to press
has been turned off. Max means that the peak of temperature and
humidity, while min is the lowest reading.
All manuals and user guides at all-guides.com
explanation
to freeze the current reading, and stop the
. To continue reading the measured
for two seconds; a sound shows that this function
- 3 -
and press
a third time, to get the ambient
to
for a second
Advertisement
