Hanseatic HTW7512C User Manual page 81

Problem
The appliance lid This is not an error. The opening mechanism contains a safety catch that
cannot be opened keeps the appliance lid closed for approx. 2 minutes after the end of the
after the end of the course of the cycle.
course of the cycle.
Error codes
Code Possible causes
Appliance lid and/or washing drum are
E30
not closed.
Water level in the appliance is lower than
E10
the heating coil.
Pump is faulty or lint trap is clogged.
E21
Too much water in the appliance.
E12
Other problem.
EXX
Malfunction
Possible causes
Close the appliance lid and/or washing
drum properly and restart the cycle.
If the problem persists, please contact our
Service department (see page EN-38).
– The water pressure, to which the appli-
– If necessary, loosen any twists or knots
– Clean the filter in the water inlet hose
If the problem persists, please contact our
Service department (see page EN-38).
Clean lint trap (see page EN-27). If the
problem persists, please contact our
Service department (see page EN-38).
The appliance is automatically pumping
water away. After draining, switch off
the appliance, pull the mains plug out of
the socket and close the valve. Please
contact our Service department (see
page EN-38).
Please contact our Service department
(see page EN-38).
Troubleshooting table
Solutions, tips
Solutions, tips
ance is connected may be too low or the
valve may be closed. If necessary, open
the valve completely.
in the water inlet hose.
(see "Checking the water intake filter,
cleaning and replacing the gasket" on
page EN-26).
Page EN-37