Hanseatic HTW7512C User Manual page 80

Page EN-36 Troubleshooting table
Problem
Appliance is not Valve is closed.
receiving water.
Washing drum and/or
appliance lid are not closed
properly.
There is a kink in the water
inlet hose.
The water inlet hose is
clogged.
Filter on inlet is clogged.
Water is not being Outlet hose is clogged or
pumped. kinked.
The lint trap is clogged.
Water is draining Outlet hose is too low.
even though the
appliance is not
pumping.
Water is running Inlet or outlet hose is not
out (appliance is screwed on tightly enough.
"leaking").
Lint trap not closed properly.
Appliance is Transport safety device(s) was
unsteady or not/were not removed.
vibrating strongly.
Appliance was not installed or
aligned properly.
The laundry in the drum is
heavy or distributed unevenly.
Spin cycle is not The imbalance correction
running or is slow. system for imbalanced drum
loads is running.
Malfunction
Possible causes Solutions, tips
Open valve.
Close the washing drum and/or
appliance lid properly.
Check water inlet hose; dismantle if
necessary and re-align.
Clean the filter on the water inlet hose
(see page EN-26).
Clean the filter on the inlet (see
page EN-26).
Check outlet hose; dismantle if
necessary and re-align.
Clean lint trap (see page EN-27).
Place outlet hose higher.
Screw down inlet or outlet hose down
tighter.
Properly close the lint trap (see
page EN-27).
Remove transport safety device(s) (see
"Removing the transport safety devices"
on page EN-30).
Install or align appliance properly (see
"Installation site" on page EN-31).
Stop washing and restart to distribute
the laundry more evenly.
No error. Once the laundry is
distributed evenly, the spin cycle starts
automatically.