Internal Real-Time Clock
The cRIO-9022 system clock synchronizes with the internal high-precision real-time clock
during startup. This synchronization provides timestamp data to the cRIO-9022. You can use
the internal real-time clock to correct drift of the system clock.
Related Information
Internal RTC
on page 14
USB Mass-Storage Devices
The cRIO-9022 supports common USB mass-storage devices such as USB Flash drives and
USB-to-IDE adapters formatted with FAT16 and FAT32 file systems. LabVIEW maps USB
devices to the
,
U:
V:
connect multiple USB mass-storage devices to the cRIO-9022 if you use a USB hub. Refer to
the LabVIEW Help for more information.
If the cRIO-9022 is not in a hazardous location, you can connect and
Note
disconnect USB devices without affecting operation.
DIP Switches
cRIO-9022 DIP switches are in the OFF position by default.
SAFE MODE Switch
The following table describes the ON and OFF states of the SAFE MODE switch.
,
, or
drive, starting with the
W:
X:
Figure 7. Controller DIP Switches
SAFE MODE
CONSOLE OUT
IP RESET
NI cRIO-9022 User Manual and Specifications | © National Instruments | 9
drive if it is available. You can
U:
NO APP
USER1
ON
OFF