Table of Contents
Advertisement
Chapter 1 Maintenance
9.
Exit the command prompt.
This completes recovery.
6.2
Recovery of Windows Server 2008 R2
If Windows does not start normally, you can recover it by using the system recovery option.
We recommend that this option is performed by the system administrator.
For details, refer to Windows Help.
If the RAID controller driver is required, take the following steps:
1.
Turn on the power to the display and this server in that order or restart.
2.
When "Press <F2> Setup, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network" appears
on the lower left of the POST screen, press the <F3> key.
3.
Start the OS from the OS installation media.
The message "Press any key to boot from CD or DVD..." appears on the upper part of the screen.
To boot from the media, press the <Enter> key.
While boot-up proceeds, the message "Windows is loading files..." appears.
4.
Choose Repair your computer in Windows Setup wizard.
5.
Click Load Drivers, and then choose OK.
6.
Specify the following and click Add Drivers:
Specify the drive labeled INTER-FLASH.
(When using EXPRESSBUILDER DVD, specify the optical disk drive.)
For N8103-176/177/178 RAID controller:
\015\win\winnt\drivers\01_storage\1_an_01\megasas2.inf
For on-board RAID controller (LSI Embedded MegaRAID):
\015\win\winnt\drivers\01_storage\1_al_03\megasr1.inf
This completes recovery.
Tips
The volume label for each drive can be checked from the display result of the dir
command.
Example: dir C:\
Express5800/R120g-2E, T120g Maintenance Guide
6. Windows System Recovery
47
Advertisement
Table of Contents
