Operating Elements & Connections; Models Azx 212A | 215A; Modelle Azx 112A | 115A | 118A - Omnitronic AZX Series User Manual

4
OPERATING ELEMENTS & CONNECTIONS

Models AZX 212A | 215A

This user manual describes the rear panel of model AZX-215A as a reference. Illustrations and features of
the model AZX-212A are comparable.

Modelle AZX 112A | 115A | 118A

No. Function
1 Level control
For adjusting the master level.
2 Status indicators
SIGNAL: input signal is present
POWER: speaker is powered on
LIMIT: the signal level is too high; the limiter
will reduce the signal level to protect the
speakers. Reduce the volume with the
master control until the LED does not light
anymore, or only at signal peaks.
3 Mic/line input
Combo input (XLR/6.3 mm jack) for
connecting microphones or audio units with
line level output (e.g. mixer, CD player,
music instrument).
4 Tone controls HI and LOW
Adjust high and low frequencies of the
master signal.
5 Selector switch HF TRIM
To attenuate the high range.
6 Input selector switch LINE/MIC
Switches the XLR input between line and
microphone input.
• switch disengaged = microphone input
• switch engaged = line input
7 Feed-through outputs LINK
Balanced XLR jack, connected in parallel to
the input, to connect another device, e.g. a
further active speaker system.
8 Power input with fuse
Used to plug in the supplied power cord.
Only replace the fuse when the device is
disconnected from mains. Only use fuses of
the same rating and power. The correct
fuse value is specified on the rear panel.
9 Power switch
Turns power to the speaker system on and
off.
19