Assembling The Glass Wind Guard (108" Units) - Travis Industries Fire Garden 94900432 Manual

Finalizing the Installation
Assembling the Glass Wind Guard (84",108" & 132" units)
The fire pit wind guard must be used for all fire pit installations. The wind guard consists of the following parts:

(4) Top corner brackets

(4) Bottom corner brackets with rubber feet

(2) Top middle brackets

(2) Bottom middle brackets with rubber feet
Assemble the wind guard following the steps below.
NOTE: Assemble the wind guard assembly on a flat surface and use (2) people to lift it assembled wind guard and set it
in place around the linear burner.
1. Lay the glass panels out on cardboard or another soft surface that can support the full length and width of the glass
and protect them.
2. Attach the (2) top and (2) bottom corner
brackets as shown to the right (the bottom
brackets have rubber feet on them, the top
brackets do not). Use a standard
screwdriver to secure the brackets to the
glass panel (Take care not to overtighten).
Repeat this step with the second end piece
of glass.
3. Attach the (2) top and (2) bottom middle
brackets as shown to the right (the bottom
brackets have rubber feet on them, the top
brackets do not). Use a standard
screwdriver to secure the brackets to the
glass panel (Take care not to overtighten).
Repeat this step with the second end piece
of glass.
NOTE: There are Fire Garden logos on (2) of
the (4) side pieces of glass. For this step, make
sure to use one with the logo and one with no
logo. When installing the brackets on the glass
panel with the logo, make sure that the brackets
are on the opposite end from the logo (see
illustration to the right).
© Travis Industries, Inc.

(2) Glass end pieces

(2) Glass side pieces with Fire Garden logos

(2) Glass side pieces without logos.
10/26/23 - 1579
(qualified installers only)
Outdoor Complete Linear Fire Pits
29