Assembling The Glass Wind Guard; Assembling The Glass Wind Guard (48" & 72" Units) - Travis Industries Fire Garden 94900432 Manual

Finalizing the Installation
28

Assembling the Glass Wind Guard

Assembling the Glass Wind Guard (48" & 72" units)
The fire pit wind guard must be used for all fire pit installations. The wind guard consists of the following parts:

(4) Top brackets

(4) Bottom brackets with rubber feet
Assemble the wind guard following the steps below.
NOTE: Assemble the wind guard assembly on a flat surface and use (2) people to lift it assembled wind guard and set it
in place around the linear burner.
1. Lay the glass panels out on cardboard or another soft surface that can support the full length and width of the glass
and protect them.
2. Attach the (2) top and (2) bottom brackets
as shown to the right (the bottom brackets
have rubber feet on them, the top brackets
do not). Use a standard screwdriver to
secure the brackets to the glass panel
(Take care not to overtighten). Repeat this
step with the second end piece of glass.
3. Slide the end panels onto the properly
oriented side panels and secure the
brackets to the glass as shown to the right.
NOTE: There are Fire Garden logos on the
side pieces of glass. The logos should be in
the lower right corner when the glass is oriented
properly.
4. When all the clamps are secure use (2)
people to lift the assembly and place it on
the fire pit enclosure. Measure the distance
from the edges of the fire pit enclosure to
the edges of the glass to ensure that it is
centered.
© Travis Industries, Inc.

(2) Glass end panels

(2) Glass side panels
10/26/23 - 1579
(qualified installers only)
Outdoor Complete Linear Fire Pits