Travis Industries Fire Garden 94900432 Manual page 19


Connect the gas flex from the key valve (preinstalled
on the inside of the enclosure) to the incoming gas
supply line.

Connect the Gas flex from the burner assembly to
the pre-installed key valve.
NOTE: Leak test all joints before putting the firepit into
service.
With the 108X24 fire pit only, the installer must install the gas "tee" fitting as well as the flex from the tee to the key
valve (see illustration below). The tee and flex are included and shipped in the appliance hardware pack. Make
sure to leak test these connections.

Route the wires from the 24VAC transformer up through the opening in
the enclosure and the strain relief on the bottom of the electrical junction
box (below the igniter). Use listed low voltage wiring. Make sure to
provide slack in the wire for removal and service. Use wire nuts to
connect the low voltage wires to the white and yellow/white striped wires
from the control module.
© Travis Industries, Inc.
Installation
108 and 132x24 Fire Pits
10/26/23 - 1579
(qualified installers only)
ONLY
Outdoor Complete Linear Fire Pits
19