Assembling The Glass Wind Guard - Travis Industries Fire Garden 94900449 Manual

Finalizing the Installation

Assembling the Glass Wind Guard

The fire pit wind guard must be used for all fire pit installations. The wind guard consists of the following
parts:

(4) Top Brackets

(4) Bottom Brackets with Rubber Feet
Assemble the Wind Guard following the steps below.
NOTE: You will be assembling the wind guard assembly upside down and then turning it over after
completion.
1. Lay the wind guard glass out on cardboard or another soft surface that can support the full length and width
of the glass and protect them from sharp edges.
2. Take one of the end pieces of glass and position it on its
edge on a flat surface. Attach the top brackets as shown
below. Use a standard screwdriver to secure the brackets
to the glass panel (Take care not to overtighten).
NOTE: The brackets should be resting on the same surface
as the glass to ensure that they are flush with the
edge of the glass panel.
3. Attach the (2) bottom brackets (with the rubber feet facing
upward) to the same panel as shown to the right. Make
sure the edge of the metal bracket is flush with the edge of
the glass panel.
4. Set the panel with the brackets affixed aside and repeat the same steps with the other end glass panel.
5. Take one of the side glass panels and locate the Fire
Garden Logo. The logo should be in the lower right corner
when the panel is oriented correctly. After you orient the
logo so you can read it and it is in the lower right corner,
rotate the panel 180°. The logo should now be in the
upper left corner.
© Travis Industries, Inc.

(2) Glass end pieces

(2) Glass side pieces
8/17/22 - 1579
(qualified installers only)
Outdoor Complete Linear Fire Pits
25