Travis Industries Fire Garden 94900432 Manual page 30

Finalizing the Installation
30
4. Place the side glass panels
from the previous step into
the corner brackets
previously installed onto
one of the end panels. Use
a standard screwdriver to
secure the brackets to the
glass panel (Take care not
to overtighten). Repeat this
step with the second end
piece of glass.
NOTE: Make sure the logo is
readable when looking at the
outside of the wind guard.
5. Repeat the step above with the (2) side
panels without the middle brackets and the
other end panel.
NOTE: Make sure that the logo is on the
opposite side as the one in the previous step
and is readable when looking at the outside of
the wind guard.
6. Put the (2) halves of the wind guard
together and secure them by tightening the
set screws on the center brackets. Make
sure not to overtighten the screws.
© Travis Industries, Inc. 10/26/23 - 1579
(qualified installers only)
Outdoor Complete Linear Fire Pits