Garbin 4 PRO Instructions For The Installation, Use And Maintenance page 30

1 - INTRODUCTION
• The installation and/or all repairs or calibration that might afterward
become necessary must be performed with maximum diligence and
For this reason we advise you to always contact the Dealer who sold
you the machine and make sure you specify the issue, the model and
the serial number of your oven.
• In case o repairs and/or replacement of components, of extraordina-
ry maintenance, of fault or malfunction, only contact the authorized
personnel of the producer company holding the professional quali-
• Only use original spare parts.
• Before the installation, make sure the power and water distribution
values are compatible with the values indicated in the technical data
plate.
• The electrical safety of the oven is ensured by means of a connec-
periodically inspected) and it complies with the National and local
regulations in force.
• The operation and supervision of the oven during its use must be
• Avoid installing the oven next to heat sources such as: deep fryers,
• Do not obstruct the exhaust openings for any reason, do not pre-
vent the dispersion of heat and do not obstruct the steam exhaust
of the oven.
Ask the installer for instructions for the correct use of water softener/
(
cause corrosion of the equipment ).
cleaning of the oven:
- externally it must be cleaned only with a wet piece of cloth;
- the inside of the cooking chamber must be cleaned with water;
- under no circumstances can wire wool be used to clean the oven.
Failure to observe these fundamental rules may compromi
se the safety of the oven and therefore cause damage to the
user.
The producer company declines all responsibilities in case
of failure to observe the norms contained in this guide, both
by the user and the technician in charge with the installation
and no potential incident or damage caused by such non
compliance can be attributed to it.
-