Becker CentronicPLUS SWC541A PLUS Assembly And Operating Instructions Manual page 8

Identification of the hand-held transmitter
A colour can be assigned to the LED ring of the hand-held transmitter by
pressing the function button to make the device easier to identify. The stored
colour can be displayed by briefly pressing the function button. If the function
button is pressed for longer than 3 seconds, the LED ring flashes briefly. The
required colour can now be set by pressing the
available: press the function button again for longer than 3 seconds to store
the colour currently selected.
Battery status
Intermediate position I + II
The intermediate positions I + II are freely selectable positions for the shading
solution between the two limit positions. Each travel button can be assigned
one intermediate position. Both limit positions must be set before an interme-
diate position is set.
Whether or not this function is available depends on the devices used and is
described in the relevant instructions for the receiver.
Thresholds
The function button can be used to retrieve and set thresholds for sensors.
Whether or not this option for setting values is available depends on the
devices used and is described in the relevant instructions for the sensor.
8 - en
Battery status low
LED ring flashes yellow 4 times following normal
feedback.
Battery status empty
LED ring flashes red 4 times following normal
feedback.
or button. 9 colours are