Becker CentronicPLUS SWC541A PLUS Assembly And Operating Instructions Manual page 7

Keypad , ,
• Drive commands
• Manual/automatic mode switching
• Intermediate position I + II
Function button
• Identification of the transmitter
• Retrieval/setting of thresholds
• Retrieval/setting of rain reaction
Programming button
• Environment scan, as well as selection and programming of receivers
• Add and remove receivers to/from the installation
• Restore factory settings
• Add additional transmitters to the installation
manual / automatic
You can display and select the "Manual" or "Automatic" setting by pressing the
STOP button. Only manual drive commands and emergency signals can be
performed with the "Manual" setting. In addition, automatic drive commands
are also performed in the "Automatic" setting. The automatic functions are not
interrupted if a manual drive command is carried out when in automatic mode.
3s
5s
Press the STOP button for 3 seconds to display
the current status.
Automatic The LED ring lights up green.
mode:
Manual mode: The LED ring lights up red.
Different The LED ring lights up yellow.
modes:
You can toggle between manual and automatic
mode by pressing the STOP button for 5 seconds.
7 - en