Page 1
Press and Release ™ Pop Out Mount INSTALLATION GUIDE premiermounts.com | p. 800.368.9700 | e. orders@premiermounts.com 500 W Central Ave, Suite A, Brea, CA 92821 USA 9541-000-001-0X v6.1 publ. 11/12/18...
Installation Guide Wood Stud Installation Use a pencil to mark the upper right mounting location of the wall stud. the vicinity of the mount. 2. Use a pencil to mark each of the wall studs. 1. Place the mount against the wall and align it with the pilot hole.
Page 4
Installation Guide 1. Level the mount Drill a pilot hole in each of the three (3) marks with a 2. Use a pencil to mark the remaining three (3) power drill and a M6 or 1/4” drill bit. mounting locations 1.
Installation Guide Concrete Wall Installation Two people recommended for this step; one person Drill a pilot hole in each of the four (4) mark areas to level the mount and another person to mark the with a 3/8” masonry drill bit. mounting locations.
Page 6
LMV large matrix video wall. Plumb and level and mark each corner where the LMV will be mounted (or secure to the wall).
Installation Guide Selecting the Mounting Hardware Insert a small straw or toothpick into the threaded inserts found Use a pencil to mark the depth of the threaded insert on the small straw or toothpick. Mark the straw or toothpick 1/8” above the depth of the threaded insert, as shown in Figure 1.
Installation Guide Universal Washer Installation Universal Washers are designed to accommodate the various M5, M6 Identify the number and location of the thread inserts on the Aligning the holes on each mounting bracket with the thread minimum of two (2) screws per bracket. Do not over tighten the mounting hardware.
Engage the top and bottom mounting brackets to the rails of the mount. Locking Safety Screw Installation being accidently dislodged from the LMV. Locate the pre-installed security locking safety screw at the bottom of each of the mounting brackets. Use the M5 Allen driver (supplied) to tighten the locking safety screw.
Page 10
Installation Guide MOVE INWARD Left Right Control Control BOTTOM BOTTOM MOVE OUTWARD Left Right Control Control BOTTOM BOTTOM TILT UP AND/ BOTTOM BOTTOM BOTTOM BOTTOM TILT DOWN AND/ BOTTOM BOTTOM BOTTOM BOTTOM premiermounts.com | p. 800.368.9700 | e. orders@premiermounts.com Page 10...
Page 11
Installation Guide LEVEL UP Left Right Control Control LEVEL LEVEL LEVEL DOWN Left Right Control Control LEVEL LEVEL ROTATE LEFT Left Right Control Control LEVEL LEVEL ROTATE RIGHT Left Right Control Control LEVEL LEVEL premiermounts.com | p. 800.368.9700 | e. orders@premiermounts.com Page 11...
Page 12
Installation Guide Use the GAPit GO/No Go Gauge (supplied with model specific spacer) as a final step in the process to inspect and adjust the gap to prevent costly replacement and extend the lifespan of the displays. Damage happens when weight is transferred to the ultra-thin bezels of video wall installations, This results in image distortion, and costly repairs and replacement 1.
Page 13
Installation Guide Servicing 1. Push evenly in the front of the LMV to release the single latch spring lock (Figure 1). 2. Slowly pull the front of the LMV to extend the scissor arms (Figure 2). 3. Loosen the locking safety screws on both mounting brackets.
Page 14
Premier Mounts intends to make this manual accurate and complete. However, Premier Mounts makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.