Troubleshooting; Failure Display Codes - Samsung FER710DRS Service Manual

4. Troubleshooting

4. Troubleshooting

4-1 Failure Display Codes

There is a error code and two kinds of error codes. Possible error codes
during use can be checked before service.
1. Touch 'Clock
2. Touch a number '
3. Touch 'Oven Start / Set
4. Touch 'Favorite Cook
3seconds. Error codes are displayed.
5. Touch number '0
But, if the oven turns off, the stored error codes are deleted.
6. Touch 'Oven Off
Safety error
Failure code
E-24
E-0E
Wake-Up
CAUSE
1. Disconnect power. Open the back cover.Disconnect sensor
2. Check the broil, bake and convection heater.Check the resistance
3. Check whether DLB of Main PCB, Broil, Bake and Convection
4. Check whether there is any disconnection of harness which is
Oven heating over
5. Check the resistance of oven sensor connector on main PCB.
6. It will display "E-24" after beeping 10 times Bzlong, if temperature
7. Please make sure through the method of 4-1 on 31 page, if
1. Disconnect power. Open the back cover. Check wether harness
2.
Door locking error
3. With operating door lockout, measure a voltage of connector on
4. Check whether door locking switch is being worked normally.
SOLUTION
sensor.
of the each heater.
heater relay are being worked normally.
linked with main PCB on sub PCB.
is more than 600 (316 ) during oven is working excluding the
case of self-cleaning.
those series of working for informing error take long time or not
functioned."
has been connected with door lock switch and motor.
normal one or not.
harness which is linked with door lock motor.
(Normal Voltage : AC 120V)
29
+