TOHATSU M 4C Owner's Manual page 51

4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
Oil plug specified tightening torque
·
4N·m (3 ft lb, 0.4 kgf
ENOW00095-0
CAUTION
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOF01515-0
·
m)
ENOF01516-0
INSPECTION AND MAINTENANCE
ENOW00928-1
CAUTION
If gear oil is spilled, wipe off immediately and
dispose according to the local regulations.
ENON00032-1
Note
If the gear oil color appears to be milky
color, contact your dealer.
ENOM00086-A
Propeller replacement
ENOW00084-1
WARNING
Do not install or remove propeller on the
outboard motor with spark plug caps
attached, shift in forward or reverse,
main switch at other than "OFF", engine
stop switch lock attached to the switch,
and starter key attached, or engine could
accidentally start leading to serious per-
sonal injury. Disconnecting battery cable
is recommended (if equiped).
The propeller edge is thin and sharp. Wear
the gloves while installing or removing to
protect your hands.
ENOW00086-1
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread bend both
end of the pin apart to lock propeller in
place.
A worn-out or bent propeller will lower
the outboard motor's performance, and
cause engine trouble.
51
10