Table of Contents
Advertisement
7. CONNECTION
SUPPLY MAINS
FOR SERVICEMAN ONLY
Before fitting the plug in the power supply
socket,
for
your
mentioned in the previous paragraph, please
read the following precautions.
-
The
machine's
guaranteed when it is connected to a suitable
earth system, structured as provided by the
national safety
current regulations (fig.20).
Therefore, the manufacturer cannot be held
responsible for any damage due to failure of the
grounding system of the machine.
- Always verify electrical specifications on the
data
plate
of
each
specifications always replace the information of
this manual.
- For a safe and correct installation, it is
essential to provide a suitable socket controlled
by a thermal cut-out switch whose contacts are
at least 3 mm apart, in accordance with the
current national safety regulations (see fig.20).
- WARNING: Do not locate multiple portable
socket-outlets or portable power supplies at the
rear of the appliance.
- WARNING: When positioning the appliance,
endure the supply cord is not trapped or
damaged.
- To unplug the device, first disconnect the
power supply with the switch, then grip the plug
and gently pull it out.
Important
IF THE POWER CABLE IS DAMAGED, IT MUST
BE REPLACED BY THE MANUFACTURER, ITS
AFTER SALE SERVICE OR BY QUALIFIED
PERSONNEL, TO PREVENT ANY POSSIBLE RISK.
Edition: October, 2023
TO
THE
POWER
own
safety,
as
electrical
safety
is
machine.
Data
already
only
plate
- If required by local regulations, it is
possible to have the appliance permanently
connected to electrical power supply, ref.
National Electrical Code (NEC) and NFPA
70. If this is the case, it is necessary to
remove the right side panel, disconnect the
power cable from the machine wiring,
remove it from the machine and replace it
with the permanent cable by respecting the
local codes.
Revision: 0
Fig. 20
Pag.: 14/28
Advertisement
Table of Contents
