Table of Contents
Advertisement
GB
CONTENTS
INSTALLATION AND OPERATION DRAWINGS ............. 2
WARNINGS ...................................................................... 6
I.
1.
Data plate ............................................................ 6
2.
Technical data ..................................................... 6
3.
Positioning ........................................................... 6
4.
Connections ......................................................... 6
4.1
Connection to water mains .................................. 6
4.2
Electrical connection ............................................ 7
5.
Safety devices ...................................................... 7
6.
Operation check ................................................... 7
7.
Servicing ............................................................... 7
8.
Troubleshooting ................................................... 7
II.
1.
Instructions for the user ........................................ 8
2.
Turning on ............................................................ 8
3.
Turning off ............................................................ 8
4.
Care and maintenance ........................................ 9
5.
Warnings .............................................................. 9
Spare parts list ..................................................... 10
WARNINGS
• Carefully read this instructions manual, inasmuch as it
contains important information concerning the safety,
operation and maintenance of this appliance.
Keep this instructions manual in a safe place for future
consultation by other users.
• Installation of this appliance must only be performed
by a qualified installer in compliance with the manufac-
turer's instructions.
• The appliance must only be used by trained personnel.
• Switch off the appliance if it breaks down or malfunc-
tions.
Only contact the technical service centre authorised by
the manufacturer for repairs and only use original spare
parts.
• Failure to comply with the above instructions may
jeopardise the safety of the appliance.
0270 03600
Page
I.
INSTALLATION INSTRUCTIONS
The appliance must be installed by a qualified installer in
compliance with current safety standards.
1.
DATA PLATE
The data plate is mounted at the bottom on the RH side of the
appliance.
2.
TECHNICAL DATA
Installation diagram (see Figs. 1a and 1b)
Model LV300R- LV301R
B - Cold drinking water connection UNI ISO 228/1-G1
Electric power supply (50 Hz)
Wash pump power
Basket lifting motor power
Power consumption
Power cable cross-section
Net weight
Tank capacity
Cycle load
Cycle length
Model LV500 - LV501
B - Cold drinking water connection UNI ISO 228/1-G1
Electric power supply (50 Hz)
Wash pump power
Basket lifting motor power
Power consumption
Power cable cross-section
Net weight
Tank capacity
Cycle load
Cycle length
3.
POSITIONING
• The LH side of the appliance must be positioned at least 700
cm from the wall or other units to provide easy access to the
water circulating pump. Maintenance work is normally car-
ried out from the front of the appliance.
• The installation floor must be capable of withstanding a total
weight of 800 Kg/sq.m.
• Place the appliance in the required position and level it to
the required height using the adjustable feet (+50 mm).
• Carefully remove the protective film from the external panels
to avoid leaving any trace of glue.
Use a suitable diluent such as petrol or paraffin to remove
any glue residue.
4.
CONNECTIONS
4.1
CONNECTION TO WATER MAINS
• The appliance must be connected to a "drinking water" sup-
ply as stipulated by:
- DPR 236, 24-5-1988
- Department of Health Decree Nr. 443, 29-1-91.
- Subsequent amendments and modifications.
6
V
400 3N~
kW
1.1
kW
0.1
kW
1.2
mm
2
1.5x5
kg
250
l
330
kg
10-40
mins. 2-3
V
400 3N~
kW
1.1
kW
0.1
kW
1.2
mm
2
1.5x5
kg
300
l
520
kg
14-70
mins. 2-3
Advertisement
Table of Contents
