Control And Replacement Of Seals; Winter Storage; Product Storage; Disclaimer - Electrolux SP New R452a Operator's Manual

Control and replacement of seals

EVAPORATOR HARD SEAL AND ITS
SILICONE WASHER
Replace every 9 to12 months according to the
conditions of use and level of maintenance.
BOWL GASKET (LOCATED AT THE REAR OF
BOWL)
Replace it every 12 months according to the
conditions of use and level of maintenance.
DISPENSE VALVE O-RING
The dispense valve o-rings should be replaced
as necessary when wear is evident. Lubricate
them each time they are replaced or the
dispense valve is removed for cleaning.
SUCTION GASKET
Replace every 3 months according to the
conditions of use and level of maintenance. This
part should be lubricated during the re-
assembly after every cleaning with Vaseline.

Winter storage

To protect the unit during seasonal shutdown,
it's important to properly store the machine
using the following procedures:
- Disconnect all power to the freezer.
- Disassemble, wash and sanitize all parts that
come into contact with the mix as described in
chapter 1.
- Clean also all the exterior panels.
- Reassemble all these parts.
- Cover the machine with the original package
to protect it from dust or other contaminating
elements.
- Place the machine in dry location.
Edition: October, 2023

Product storage

Since the safety of the product used with this
unit depends upon the temperature and the
duration of storage, it is necessary to refer
directly to the food product producer instruction
and specifications in order to correctly manage
it and in order to avoid any possible safety
issue.

12. DISCLAIMER

The manufacturer declines all responsibility for
any damage that directly or indirectly might be
brought on to people, things, animals, as a
consequence of failure to comply with all
instructions given in this manual with the
warnings concerning installation procedures, use
and maintenance of the machine.
The manufacturer cannot be held responsible for
possible mistakes due to printing, copying or
translating errors contained in this manual.
In addition, the manufacturer reserves the right
to modify what deemed necessary or useful for
the machine, as well as for the benefit of the
user, yet at the same time maintaining the
essential operative and safety characteristics of
said machine.
Revision: 0 Pag.: 20/28