Lincoln Electric VRTEX TRANSPORT+ Operator's Manual page 25

Table of Contents

Advertisement

VRTEX
360, 360+, TRANSPORT, TRANSPORT+
®
Figure 21 – Lower pole section installation
LOWER POLE
SECTION
TOP STAND
BASE SCREW
BOTTOM STAND
BASE SCREW,
NUT AND WASHER
7. Using a slotted screwdriver, remove the two screws from the top
of the lower pole. Retain the two screws. See Figure 22.
Figure 22 – Pole screws
POLE
SCREWS
8. Carefully position the table assembly onto the lower pole. See
Figure 23.
9. Carefully position the coupon arm onto the lower pole. See Figure
23.
10. Carefully position the monitor arm onto the lower pole. See
Figure 23.
CAUTION
Use caution when unpackaging the monitor arm
assembly. The monitor arm is under tension and can
spring open, handle with care.
Figure 23 – Stand component installation
MONITOR ARM
COUPON ARM
TABLE
ASSEMBLY
11. Carefully position the top pole onto the lower pole and align the
position numbers. See Figure 24.
Figure 24 – Top pole section installation
12. Using a slotted screwdriver, attach the two previously removed
screws (in step 7) securing the top and lower poles together.
NOTE: Do not over-tighten the screws, this can damage the lower
pole.
13. Using the four thumb screws (found in device box), secure the
monitor to the monitor arm.
14. Carefully raise the monitor arm to position 16 and secure in place
with a pin. See Figure 25.
15. Carefully raise the coupon arm to position 10 and secure in place
with a pin. See Figure 25.
16. Carefully raise the table assembly to position 3 and secure in
place with a pin. See Figure 25.
17. Place a pin in the center of the coupon arm to hold the coupon
parallel to the table. See Figure 25.
Figure 25 – Stand component positions
18. Connect the coupon arm amphenol to the rear of the machine.
19. Connect the USB, DisplayPort and power cables to the appropriate
ports on the bottom of the monitor.
20. Route cables thru the cable holder on the bottom of the monitor
arm.
21. Connect the USB, DisplayPort and power cables to the appropriate
ports on the rear of the machine.
16
INSTALLATION
MONITOR ARM PIN
COUPON ARM PIN
COUPON PIN
TABLE PIN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vrtex 360+Vrtex transport12923129241292512929

Table of Contents