Table of Contents
Advertisement
3.
Press the Band button repeatedly to select the desired frequency band.
4.
To scan up in frequency, first rotate the Tuning control knob in a clockwise direction and then press the Tuning
control knob. Your radio will scan in an upwards direction (low frequency to high frequency) and stop automatically
when it finds a station of sufficient strength. To scan down in frequency, first rotate the Tuning control knob in an
anti-clockwise direction and then press the Tuning control knob. Your radio will scan in a downwards direction and
stop automatically when it finds a station of sufficient strength.
5.
After a few seconds the display will update. The display will show the frequency of the signal found. If the signal is
strong enough and there is RDS / RBDS data present then the radio will display the station name.
Manual tuning – FM / AM
1.
Press the Power button to switch on your radio.
2.
Press the Band button repeatedly to select the desired frequency band.
3.
Rotate the Tuning control knob to tune to a station. The frequency will change in steps of 50kHz / 100kHz /
200kHz in FM or 9kHz / 10kHz in AM.
4.
When the frequency band end is reached the radio will recommence tuning from the opposite frequency band
end.
5.
Adjust the Volume control to the desired volume settings.
6.
To switch off your radio press the Power button.
NOTE
If your radio has any interference in the AM band because of its adaptor, please move your radio away from its AC
adaptor at least 12".
Presetting stations
There are 20 presets (4pages x 5presets) each for FM and AM radio. They are used the same way for each operating
mode.
1
Press the Power button to switch on your radio.
2
Tune to the required radio station as previously described.
3
To store the station as a preset, press the Page button to select the
required preset page 1 to 4 and then press and hold the required preset
button (1-5) until you hear a beep and the display will show the page and
the memory pre-set you selected. e.g. "
4
Stations which are already stored in the presets may be overwritten by following the above procedure.
Recalling a preset station
1.
Press the Power button to switch on your radio.
2.
Select the required operating mode using the Band button.
3.
Press the Page button to select the required preset page and momentarily press the required Preset button, your
radio will tune to the station stored in the selected preset memory. The chosen preset number is shown in the
upper right hand side of the radio display, e.g. "
NOTE
The display will show "Preset xX Empty" if no station has been stored to that preset.
".
".
GB
E
05
Advertisement
Table of Contents
