Manual Tuning - Fm/Am; Presetting Stations - Sangean HD Radio HDR-14 Manual

Manual tuning – FM/AM
1. Press the Power button to switch on your radio.
2. Press the Band button repeatedly to select the desired frequency band.
3. Press and release the Tuning up/down button to tune to a station. The
frequency will change in steps of 50kHz/100kHz/200 kHz in FM or 9 kHz/10
kHz in AM.
4. When the frequency band end is reached the radio will recommence
tuning from the opposite frequency band end.
5. Adjust the Volume control to the desired volume settings.
6. To switch off your radio press the Power button.
Note:
If your radio has any interference in the AM band because of its adaptor,
please move your radio away from its AC adaptor at least 12".

Presetting stations

There are 20 presets (4 pages x 5 presets) each for FM and AM radio. They
are used the same way for each operating mode.
1. Press the Power button to switch on your radio.
2. Tune to the required radio station as previously described.
3. To store the station as a preset, press the Page button to select the
required preset page 1 to 4 and press and hold the required preset
button (1-5) until you hear a beep and the display will show the page and
the memory pre-set you selected. e.g. "
4. Stations which are already stored in the presets may be overwritten by
following the above procedure.
10
".