Adjusting The Tracking; Checking The Tire Pressure; Checking The Wheel Lug Nuts - Toro 72958 Operator's Manual

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. Engage the parking brake, shut off the engine,
and remove the key.
7. Adjust the stop plates as needed.
•
If the machine tracks to the right, loosen the
bolts and adjust the left stop plate rearward
on the left T-slot until the machine tracks
straight (Figure
•
If the machine tracks to the left, loosen the
bolts and adjust the right stop plate rearward
on the right T-slot until the machine tracks
straight (Figure
8. Tighten the stop plate
Figure 63
Left control lever shown
1. Control lever
2. Bolt
-L
EUTRAL OCK
AST
63).
63).
(Figure 63).
3. Stop plate

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
Maintain the air pressure in the front and rear tires
at 90 kPa (13 psi). Uneven tire pressure can cause
uneven cut. Check the tires when they are cold to get
and
the most accurate pressure reading.
Checking the Wheel Lug
Nuts
Check and torque the wheel lug nuts to 122 to 129
N∙m (90 to 95 ft-lb).
g010153
50
comes first)
Figure 64
g001055