Table of Contents
Advertisement
sides of the brake pole as shown in
71
and
Figure
Note:
Due to the way the rotor and the
armature faces wear (peaks and valleys) it
is sometimes difficult to measure the gap
accurately.
Figure 71
1. Feeler gauge
Figure 72
1. Feeler gauge
•
If the gap is less than 0.25 mm (0.01
inch), then install the shim.
•
If the gap is sufficient, proceed to the
safety check in step F.
F.
Perform the following safety check:
i.
Sit on the seat and start the engine.
ii.
Make sure that the blades do not
engage with the blade-control switch
(PTO) in the O
the clutch is disengaged.
If the clutch does not disengage,
install the shim again.
iii.
Engage and disengage the
blade-control switch (PTO) 10
consecutive times to ensure that the
clutch is functioning properly.
Figure
72.
position, and that
FF
Cooling System
Maintenance
Cleaning the Engine Screen
and Engine-Oil Cooler
Service Interval: Before each use or daily
Remove any buildup of grass, dirt, or other debris
from the oil cooler and the engine screen
g010872
g010873
Remove any buildup of grass, dirt, or other debris
from the engine screen. This helps ensure adequate
cooling and correct engine speed and reduces the
possibility of overheating and mechanical damage to
the engine
(Figure
53
Figure 73
70).
(Figure
73).
g008804
g009191
Advertisement
Table of Contents
