Specifications - Toro 72958 Operator's Manual

Fuel Gauge
The fuel gauge is located within the hour meter, and
the bars light up when the key switch is in the O
position (Figure 6).
The indicator light appears when the fuel level is low
(approximately 1 gallon remaining in the fuel tank).
Safety-Interlock Indicators
There are symbols on the hour meter that indicate
with a black triangle that the interlock component is
positioned correctly (Figure
Battery-Indicator Light
If you turn the key switch to the O
few seconds, the battery voltage displays in the area
where the hours are normally displayed.
The battery light turns on when the key switch is
turned on and when the charge is below the correct
operating level (Figure
Electronic-Control Unit
Malfunction-Indicator Light
The electronic-control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) illuminates.
The MIL is the red light located in the right console
panel.
Once the MIL illuminates, make initial troubleshooting
checks; refer to the MIL section under
(page 72).
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
Neutral-Lock Position
Move the motion-control levers outward from the
center to the N -
EUTRAL
the machine (Figure 22). Always position the
motion-control levers into the N
when you stop the machine or leave it unattended.
Parking-Brake Lever
Whenever you shut off the engine, engage the parking
brake to prevent accidental movement of the machine.
6).
position for a
N
6).
Troubleshooting
(Figure
position when exiting
LOCK
- position
EUTRAL LOCK
Fuel-Shutoff Valve
Close the fuel-shutoff valve when transporting or
N storing the machine; refer to
Valve (page 31).
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.

Specifications

Note:
Specifications and design are subject to
change without notice.
Width:
Without Deck
Deflector Up
Deflector Down
Length:
Roll Bar - Up
Roll Bar - Down
Height:
Roll Bar - Up
179 cm (71 inches)
Weight:
4).
Model
72958
13
Using the Fuel-Shutoff
135 cm (53 inches)
157 cm (62 inches)
192 cm (76 inches)
211 cm (83 inches)
215 cm (85 inches)
Roll Bar - Down
119 cm (47 inches)
Weight
532 kg (1,172 lb)