Table of Contents
Advertisement
5.
Place a drain pan under the filter, remove the
old filter, and wipe the surface clean
Bottom view of the machine
1. Filter locations
6.
Apply a thin coat of hydraulic fluid to the rubber
gasket on the replacement filter
7.
Install the replacement hydraulic filter.
8.
Install the pump-drive belt and the mower belt.
9.
Remove the jack stands and lower the machine
(Figure
87).
10.
Add fluid to the hydraulic reservoir and check
for any leaks.
11.
Clean up any spilled fluid.
12.
Start the engine and let it run for about 2 minutes
to purge air from the system.
13.
Shut off the engine and check for leaks.
14.
Check the fluid level while the fluid is cold.
15.
If required, add fluid to the hydraulic reservoir.
Note:
Do not overfill.
(Figure
Figure 88
2. Hydraulic filter
(Figure
88).
g008968
88).
62
Advertisement
Table of Contents
