Intrusion Switch Module; Removing The Intrusion Switch Module - Dell EMC PowerEdge R750xs 60KKP Installation And Service Manual

Table of Contents

Advertisement

Figure 34. Installing the side wall bracket
Next steps
1.
Install the air
shroud.
2.
Install the backplane cover.
3. Follow the procedure listed in the

Intrusion switch module

This is a service technician replaceable part only.

Removing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
Steps
1. Remove the power cable from the power interposer board and the system board and then disconnect and remove the
intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
3. Lift the intrusion switch module out of the system.
46
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Emc poweredge r750xsE75s seriesE75s001

Table of Contents