Removing The Expansion Card Risers - Dell EMC PowerEdge R750xs 60KKP Installation And Service Manual

Table 34. Configuration 5: No Riser (continued)
Card type
Intel (NIC: 10Gb)
Qlogic (NIC: 10Gb)
Broadcom (NIC: 1Gb)
Intel (NIC: 1Gb)
Mellanox (NIC: HDR100 VPI)
Mellanox (NIC: HDR VPI)
Broadcom (OCP: 25Gb)
Intel (OCP: 25Gb)
Marvell (OCP: 25Gb)
Mellanox (OCP: 25Gb)
SolarFlare (OCP: 25Gb)
Broadcom (OCP: 10Gb)
Marvell (OCP: 10Gb)
Intel (OCP: 10Gb)
Broadcom (OCP: 1Gb)
Intel (OCP: 1Gb)
Dell External PERC Adapter
Dell BOSS S1 Module
Samsung (PCIe SSD AIC)
Intel (PCIe SSD)

Removing the expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Disconnect all the riser cables from the system board.
Steps
For Riser 1A and Riser 1B, loosen the two thumb screws with Phillips #2 screwdriver and pull up the expansion card riser.
Slot priority
1, 2
1, 2
1, 2
1, 2
Not supported
Not supported
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
1, 2
Integrated slot
1, 2
Not supported
Safety instructions.
Before working inside your
Maximum number of cards
4
4
4
4
N/a
N/a
1
1
1
1
1
1
1
1
1
1
4
1
4
N/a
system.
Installing and removing system components 91